Step 2: Remove Loudspeaker - Cisco TelePresence MX800 Single Replacement Manual

Cisco TelePresence MX800 Single
Contents
Replace a loudspeaker

Step 2: Remove loudspeaker

The same procedure applies for
loudspeakers in all positions.
When reconnecting the loudspeakers,
make sure to connect the correct cable.
Remove screw.
2a
PT4x10, Torx T20
Re-assembly:
In order to install the new loudspeaker, follow all the steps in reversed order.
D15298.01 MX800 Single Replacement Guide, MARCH 2015.
Introduction Grilles and covers
(page 2 of 2)
2b
Speakers and cameras Speakers and cameras
Pull loudspeaker 10-15 cm (4-6 inch) out.
12
Replacement Guide
Codec and monitor
Unplug the cable from the connector on
2c
the back of the loudspeaker.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendix