Advertisement
Front flush cuts
Loosen the bolt on the back
of
the base
with the hex wrench, then slide the base
backwards. Check the contact between the
back edge of the blade and support roller,
then secure the bolt.
Bevel cutting
1. With the base tilted, you can make bevel
cuts
a t
any angle between 0 ' and 45'
(left to right).
2.
Loosen the bolt on the back
of
the base
with the hex wrench. Tilt the base to
the desired angle. The edge of the hous-
ing indicates the bevel angle. (Fig. 11).
Then check for contact between the
back edge of the blade and the roller.
Now tighten the bolt securely on the
back of the base.
Fig. 9
1
I
Edge of housing
Roller
I
1
Fig. 11
8
Advertisement
