Advertisement
14.
REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking t o
see that keys and adjusting wrenches are removed from tool before turn-
ing
it
on.
15.
AVOID UNINTENTIONAL STARTING. Don't carry plugged-in tool with finger
on switch. Be sure switch is OFF when plugging in.
16. OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only
extension cords intended for use outdoors and
so
marked.
17. STAY ALERT. Watch what you are doing, use common sense. Don't oper-
ate tool when you are tired.
18.
CHECK DAMAGED PARTS. Before further use of the tool, a guard
or
other
part that is damaged should be carefully checked t o determine that
it
will
operate properly and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation. A guard or other part
that
is
damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in this instruction manu-
al. Have defective switches replaced by authorized service center. Don't
use tool if switch does not turn
it
on and off.
19.
GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded
surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
20.
REPLACEMENT PARTS. When servicing, use only identical replacement
parts.
VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source
with
voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user
-
as well as damage t o
the tool. If in doubt, DO NOT PLUG
IN
THE TOOL. Using a power source with
voltage less than the nameplate rating
is
harmful t o the motor.
3
Advertisement
