Advertisement
Switch action
Tool
speed
is
increased by increasing pres-
sure on the trigger. To start the tool, simply
pull the trigger.
Release
the trigger to stop.
For continuous operation, pull the trigger
and then push in the lock button. To stop
the tool from the locked position, pull the
trigger fully, then release it. A speed con-
trol screw
is
provided
so
that maximum
tool speed can be limited (variable). Turn
the speed control screw clockwise for
higher speed, and counterclockwise for
lower speed.
Speed
control screw
Lock button
r
Trigger switch
@
Lower
M
'
Fig.
CAUTION
:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to the "OFF" position when released.
Operation
Turn the tool on before contacting the
workpiece. Then rest the base flat on the
workpiece and gently move the tool for-
ward along the previously marked cutting
line.
Plunge cutting
.Starting
a
cut
a t
other than the edge of
the workpiece without first drilling a
starting hole requires a "plunge cut". This
can be accomplished by tipping the tool
forward until the front end
of
the base
rests against the workpiece. Switch the
tool
on
and lower the back end of the
tool slowly, gradually allowing the blade
to saw through the wood until the base
is able to s i t flat on the workpiece. You
may then proceed forward with the cut in
a normal manner.
0
If using
a
drill for
a
starting hole, bore
a hole over 12 mm (1/2") in diameter.
Then insert the blade in
it
and proceed.
L . - B a s e
Fig.
7
Fig.
I
7
Advertisement
