Advertisement
3. Now attach the universal blade clamp to
1
the blade holder (blade in place)
so
that
the spring pin fits into the hole on the
blade holder. Tighten the bolt securely
with the hex wrench (Fig. 4).
Using roller
With the hex wrench, loosen the bolt
which holds the base and retainer. Slide
the retainer so that the roller contacts the
blade, then tighten the bolt. However, when
the blade you use does not have
a
straight
back, slide the retainer back so that the
roller will not contact
the
blade.
Fig.
\
Retatner
I
Fig.
Use
a
lubricant or cutting oil between the blade and roller when cutting iron or composi-
tion board, etc. Failure to do so will shorten the service life of your blade and roller.
6
Advertisement
