Makita HR3200C Instruction Manual
Hide thumbs
Also See for HR3200C:
- Instruction manual (72 pages) ,
- Technical information (24 pages) ,
- Instruction manual (49 pages)
Related Manuals for Makita HR3200C
Summary of Contents for Makita HR3200C
- Page 1 INSTRUCTION MANUAL Rotary Hammer HR3200C HR3210C HR3210FCT 008536 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
Safety class • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country. END201-4 For Model HR3200C ENG102-1 Symbols For European countries only The following show the symbols used for the equipment. -
Page 3: General Power Tool Safety Warnings
(tri-axial vector sum) Authorized Representative in Europe: determined according to EN60745-2-6: Makita International Europe Ltd. Work mode : chiseling function Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 Vibration emission (a ) : 7.5 m/s 8JD, ENGLAND h,CHeq Uncertainty (K) : 1.5 m/s... -
Page 4: Specific Safety Rules
10. Stay alert, watch what you are doing and use 21. Maintain power tools. Check for misalignment common sense when operating a power tool. or binding of moving parts, breakage of parts Do not use a power tool while you are tired or and any other condition that may affect the under the influence of drugs, alcohol or power tool’s operation. -
Page 5: Functional Description
used for a long time, let the tool warm up for a Lighting up the lamps while by operating it under no load. This will For Model HR3210FCT loosen up the lubrication. Without proper 1. Lamp warm-up, hammering operation is difficult. Always be sure you have a firm footing. - Page 6 The speed adjusting dial can be turned only as far Selecting the action mode • as 5 and back to 1. Do not force it past 5 or 1, or Rotation with hammering the speed adjusting function may no longer work. 1.
-
Page 7: Torque Limiter
action mode positions. CAUTION: Always use the side grip to ensure operating safety Torque limiter • when drilling in concrete, masonry, etc. The torque limiter will actuate when a certain torque The side grip swings around to either side, allowing easy level is reached. -
Page 8: Operation
Bit angle (when chipping, scaling or Use the dust cup to prevent dust from falling over the tool and on yourself when performing overhead drilling demolishing) operations. Attach the dust cup to the bit as shown in the 1. Change lever figure. -
Page 9: Maintenance
After drilling the hole, use the blow-out bulb to clean the For Model HR3200C,HR3210C dust out of the hole. Use the optional drill chuck assembly. When installing it, refer to "Installing or removing the bit" described on the Chipping/Scaling/Demolition previous page. - Page 10 008602 Wipe out the old grease inside and replace with a fresh grease (30 g). Use only Makita genuine hammer grease Loosen the two screws on crank cap cover and (optional accessory). Filling with more than the specified remove the crank cap cover.
- Page 11 Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. SDS-Plus Carbide-tipped bits • Bull point • Core bit •...
- Page 12 Makita Corporation Anjo, Aichi, Japan 884769-228...