The vibration total value (tri-axial vector sum) deter- mined according to EN60745: The following show the symbols used for the equip- Model HR3200C ment. Be sure that you understand their meaning before Work mode : hammer drilling into concrete use.
EC Declaration of Conformity Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords We Makita Corporation as the responsible manufac- increase the risk of electric shock. turer declare that the following Makita machine(s): When operating a power tool outdoors, use an Designation of Machine: extension cord suitable for outdoor use.
Page 4
Power tool use and care Be sure the bit is secured in place before operation. 18. Do not force the power tool. Use the correct power tool for your application. The correct Under normal operation, the tool is designed power tool will do the job better and safer at the to produce vibration.
NOTE: FUNCTIONAL • Use a dry cloth to wipe the dirt off the lens of DESCRIPTION lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. CAUTION: Speed change • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool.
Page 6
Changing the quick change chuck Selecting the action mode for SDS-plus Rotation with hammering For Model HR3210FCT The quick change chuck for SDS-plus can be easily exchanged for the quick change drill chuck. Removing the quick change chuck for SDS-plus ►...
For chipping, scaling or demolition operations, depress ASSEMBLY the lock button and rotate the change lever so that the pointer points to the symbol. Use a bull point, cold chisel, scaling chisel, etc. CAUTION: • Always be sure that the tool is switched off and CAUTION: unplugged before carrying out any work on the •...
The bit can be secured at 24 different angles. To change the bit angle, depress the lock button and rotate the change lever so that the pointer points to the symbol. Turn the bit to the desired angle. Depress the lock button and rotate the change lever so that the pointer points to the symbol.
Chipping/Scaling/Demolition OPERATION CAUTION: • Always use the side grip (auxiliary handle) and irmly hold the tool by both side grip and switch handle during operations. Hammer drilling operation Set the change lever to the symbol. Hold the tool irmly with both hands. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled.
These accessories or attachments are recom- wise to tighten the chuck. To remove the bit, hold the mended for use with your Makita tool speciied in this ring and turn the sleeve counterclockwise. manual. The use of any other accessories or attach- Set the change lever to the symbol.
Page 12
M a k i t a C o r p o r a t i o n 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan 884769C228 20170203 www.makita.com...