Advertisement
Installing or removing drill bit or driver bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge
is
removed before
installing or removing the bit.
To install the bit, push the sleeve up to-
ward the "FREE" side and turn the sleeve
counterclockwise while holding the ring
Place the bit in the chuck as far as
it
will
go. Hold the ring firmly and turn the
sleeve
clockwise to tighten the chuck. Then push
the sleeve down toward the "LOCK" side.
See illustration.
Sleeve
PT
s -
To remove the bit, push the sleeve up toward the "FREE" side and turn the sleeve
counterclockwise while holding the ring with your other hand.
CAUTION :
0
Do not attempt to turn the sleeve forcibly when the sleeve is in the "LOCK" position.
The sleeve may be damaged.
0
Always push the sleeve down toward the "LOCK' side before operation. If you operate
the tool with the sleeve in the "FREE" position, the chuck may loosen and the bit may
come out unexpectedly.
7
Advertisement
