Table of Contents
Advertisement
Note:
To personalize the hotspot and change advanced settings, use a
Wi-Fi-enabled device to connect to the hotspot and then use a
browser to display the hotspot web page
http://192.168.1.1). Log in as an administrator to make changes. The
default administrator login password is admin. NETGEAR strongly
recommends that you set a more secure password.
3.
Launch your browser to surf the Internet.
Tethered Mode
You can use your hotspot in tethered mode (connected to a computer using the USB cable)
instead of connecting to it using Wi-Fi.
Note:
The first time that you use your hotspot in tethered mode, drivers are
loaded on your computer to support the hotspot.
To install drivers on devices running operating systems other than Win XP:
1.
Ensure that the hotspot is powered off.
2.
Connect the hotspot to your computer using the USB cable.
The hotspot automatically powers on and installs the necessary driver.
You can visit the hotspot web page at
your hotspot's advanced settings.
To install drivers on a computer running Windows XP:
1.
On the hotspot, hold both the Power and Navigation keys down for five seconds.
2.
Press the Navigation key until Install Win XP drivers is highlighted.
3.
Press the Power key.
4.
Follow the instructions to enable device driver installation mode.
5.
Connect the hotspot to your computer using the USB cable.
The hotspot installs the necessary driver.
Once the driver is installed, you can visit the hotspot web page at
http://192.168.1.1
Telstra Pre-Paid 4G My Pocket Wi-Fi Ultimate
http://m.home
to customize your hotspot's advanced settings.
Get Started
14
(http://m.home
or
or
http://192.168.1.1
http://m.home
to customize
or
Advertisement
Table of Contents
