Configuring Ntp Server - HIKVISION DS-2CD7153-E User Manual

Password: Enter the password of the device. By default it is 12345.
5. Click the Apply button to save and exit the interface.

9.2.3 Configuring NTP Server

Purpose:
A Network Time Protocol (NTP) Server can be configured on your DVR to ensure the accuracy of system
date/time.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the NTP tab to enter the NTP Settings interface.
3. Check the Enable NTP checkbox to enable this feature.
4. Configure the following NTP settings:
•
Interval: Time interval between the two synchronizing actions with NTP server. The unit is minute.
•
NTP Server: IP address of NTP server.
•
NTP Port: Port of NTP server.
5. Click the Apply button to save and exit the interface.
Note:
The time synchronization interval can be set from 1 to 10080 minutes, and the default value is 60
minutes. If the DVR is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address: 210.72.145.44). If
the DVR is set in a more customized network, NTP software can be used to establish a NTP server used
for time synchronization.
User Manual of Digital Video Recorder
Figure 9. 12 Access Device via NVMS7000
Figure 9. 13 NTP Settings Interface
114