Connecting Wires To Terminals - Kenwood DDX9902S Instruction Manual

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connection

Connecting wires to terminals

USB input terminal (1.0 m):
Pages 67 – 68
GPS antenna terminal:
Page 70
Connect the antenna
cord to the antenna
terminal.
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Antenna control wire)
Blue with white stripe (Power control wire)
Brown (Mute control wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
66
Pages 67 – 69 Pages 67 – 69
Page 69
Purple with white stripe
(Reverse sensor wire)
Light green (Parking
sensor wire)
10 A fuse
Connect SiriusXM Connect Vehicle Tuner
(commercially available). See page 69.
Depending on what antenna you are using, connect either to the control
*
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier, connect to its power control terminal.
Not used.
To use the steering wheel remote control feature, an exclusive remote adapter
(not supplied) matching your car is required.
To car light control switch
(ACC)
(BATT)
(GND)
Connect to the vehicle's reverse lamp harness when
using the optional rear view camera.
Connect to the vehicle's parking
3
brake detection switch harness.
• For best safety, be sure to
connect the parking sensor.
* If no connections are made, do not let the cable come out from the
tab.
Ignition key switch
To car chassis
Fuse box
Battery