Connecting Wires To Terminals - Kenwood KDC-BT850RN Instruction Manual

Connecting Wires to Terminals

Front side
REMO.CONT
⁄
To use the steering wheel remote control feature, you
need to an exclusive remote adapter (not supplied)
matches your car is required.
Fuse (10A)
Wiring harness
(Accessory1)
TEL mute wire (Brown)
If no connections are made, do not
let the wire come out from the tab.
Power control/Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
Connector A
8 6 4 2
7 5 3 1
8 6 4 2
Connector B
7 5 3 1
40
|
KDC-BT6544U/ KDC-BT6544UY/ KDC-BT6044/ KDC-BT6144/ KDC-W5544U/ KDC-W5644U
AUX input (Stereo)
Use the mini-plug cable which is stereo type
and does not have any resistance.
USB connector (KDC-BT6544U/BT6544UY/
W5544U/W5644U only)
Steering remote control (Light Blue/Yellow)
FM/AM antenna input (JASO)
To Kenwood disc changer/External optional accessory
(KDC-BT6544U/BT6544UY/ W5544U/W5644U only)
MUTE
P.CONT
ANT.CONT
See next page
A–7 Pin (Red)
A–4 Pin (Yellow)
KDC-BT6544U/KDC-BT6544UY
R L
Rear output
Front output
Sub Woofer output
KDC-BT6044/KDC-BT6144/KDC-W5544U/KDC-W5644U
R L
Rear output/Sub Woofer output
Antenna Cord
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
(KDC-W5544U/W5644U only)
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.