Kenwood DDX9902S Instruction Manual page 47

BLUETOOTH BLUETOOTH
Pairing a Bluetooth device from this unit using a
PIN code (for Bluetooth 2.0)
1
Display the <Bluetooth Setup> screen.
(Page 46)
2
3
Search for the available devices.
• To cancel searching devices, press [Cancel].
4
Select the device you want to pair.
• If a PIN code is required, enter "0000" (initial).
Connecting/disconnecting a registered
Bluetooth device
Two devices can be connected simultaneously.
1
Display the <Bluetooth Setup> screen.
(Page 46)
2
3
Select the device you want to connect (1),
then press [Connection] (2).
4
Select [ON] or [OFF] for the target.
: Mobile phone
: Audio device
• The status is shown as follows:
– "Connected": A connection has been
established.
– "Connect Ready": A connection can be
established.
– "Disconnected": No connection is
established.
• Press [Change] for <APP Setup> to display
the <APP Settings> screen to configure
settings for applications of iPod/iPhone/
Android. (Page 53)
• When a Bluetooth mobile phone is connected,
the signal strength and battery level are displayed
when the information is acquired from the device.
Deleting a registered Bluetooth device
1
Display the <Bluetooth Setup> screen.
(Page 46)
2
3
Select a device to delete (1), then press
[Remove] (2).
A confirmation message appears. Press [Yes].
ENGLISH 47