Connecting Wires To Terminals - Kenwood DPX-MP4050B Instruction Manual

Connecting Wires to Terminals

To car light control switch
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
Ignition key
switch
Car fuse box
(Main fuse)
Car fuse box
Battery
+ –
FM/AM antenna input
Dimmer control wire
(Orange/White)
ILLUMI
Power control wire
(Blue/White)
P.CONT
Motor antenna control wire
(Blue)
ANT CONT
Ignition wire (Red)
ACC
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
— 30 — — 30 —
Fuse (10A)
Wiring harness
(Accessory2)
White/Black
+
White
Gray/Black
+
Gray
Green/Black
+
Green
Purple/Black
+
Purple
Front left output (White)
Front right output (Red)
Rear left output (White)/
Non-fading left output (White)
Rear right output (Red)/
Non-fading right output (Red)
KENWOOD disc changer control input
NOTE
To connect the Disc changer,
consult your Disc changer manual.
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker