Installing Your Router; Hardware Installation - Draytek Vigor2960 Series Quick Start Quide

2 . I n s t a l l i n
2 . I n s t a l l i n
This section will guide you to install the router through hardware connection and
configure the router's settings through web browser.
2 . 1 H a r d w a r e
2 . 1 H a r d w a r e
Before starting to configure the router, you have to connect your devices correctly.
1. Connect one end of an Ethernet cable (RJ-45) to one of the LAN ports of
Vigor2960s.
2. Connect the other end of the cable (RJ-45) to the Ethernet port on your computer
(that device also can connect to other computers to form a small area network). The
LAN LED for that port on the front panel will light up.
3. Connect the cable Modem/DSL Modem/Media Converter to any WAN port of router
with Ethernet cable (RJ-45).
4. Connect the power cord to Vigor2960's power port on the rear panel, and the other
side into a wall outlet.
5. Power on the device by pressing down the power switch on the rear panel. The PWR
LED should be ON.
6. The system starts to initiate. After completing the system test, the ACT LED will
light up and start blinking.
(For the detailed information of LED status, please refer to section 1.1.)
g Y o u r R o u
g Y o u r R o u
I n s t a l l a t i o n
I n s t a l l a t i o n
t e r
t e r
5
Vigor2960 Series Quick Start Guide