Installing Your Router; Hardware Installation - Draytek Vigor2930 Series Quick Start Manual

2 . I n s t a l l i n
2 . I n s t a l l i n
This section will guide you to install the router through hardware connection and
configure the router's settings through web browser.
2 . 1 H a r d w a r e
2 . 1 H a r d w a r e
Before starting to configure the router, you have to connect your devices correctly.
1. Connect the cable Modem/DSL Modem/Media Converter to any WAN port of router
with Ethernet cable (RJ-45). The WAN1/WAN2 LED (Left or Right) will light up
according to the speed (100 or 10) of the device that it connected.
2. Connect one end of an Ethernet cable (RJ-45) to one of the LAN ports of the router
and the other end of the cable (RJ-45) into the Ethernet port on your computer. The
LAN LED (Left or Right) will light up according to the speed (100 or 10) of the
device that it connected.
3. Connect the telephone sets with phone lines (for using VoIP function). For the model
without phone ports, skip this step.
4. Connect one end of the power adapter to the router's power port on the rear panel,
and the other side into a wall outlet.
5. Power on the device by pressing down the power switch on the rear panel.
6. The system starts to initiate. After completing the system test, the ACT LED will
light up and start blinking.
(For the detailed information of LED status, please refer to section 1.1.)
Caution: Each of the Phone ports can be connected to an analog phone only. Do not
connect the phone ports to the telephone wall jack. Such connection might damage your
router.
g Y o u r R o
g Y o u r R o
I n s t a l l a t i o n
I n s t a l l a t i o n
u t e r
u t e r
11