NETGEAR C6300BD User Manual page 130

AC1900, N900, and N450 WiFi Cable Data Gateways
The following table describes the fields on the Port Triggering - Services screen.
Field
Service
Service Name
Service User
Service Type
Triggering Port
Triggering Ending Port
Inbound Connection
Starting Port
Ending Port
9. Click the Apply button.
The service or application is added to the Port Triggering Portmap Table. The Enable
check box is selected automatically.
10. In the Port Triggering section, select how the cable data gateway applies port triggering:
• Per Schedule. Port triggering is enabled according the schedule that you must select
from the menu.
For more information, see
• Always. Port triggering is always enabled.
Note: By default, the Never radio button is selected and port triggering is
disabled, even if you specified services and applications in the table.
11. Click the Apply button.
Your settings are saved.
Description
Enter a descriptive name.
From the menu, select if any internal IP address can connect to the service or
application or only a single IP address can connect. If you select Single address
from the menu, enter the IP address.
From the menu, select the correct type of protocol for the service or application
(TCP or UDP).
Enter the internal starting port number for the service or application. This number
represents the outbound traffic port that must cause the inbound ports (see
Inbound Connection later in this table) to be opened.
If the service or application uses a single triggering port, enter the same port
number that you enter in the Triggering Port field.
If the service or application uses a range of triggering ports, enter the ending port
number of the range.
Enter the starting port number for the inbound connection. This number represents
the inbound traffic port that is triggered open by the triggering port.
If the service or application uses a single ending port for the inbound connection,
enter the same port number that you enter in the Starting Port field.
If the service or application uses a range of ports for the inbound connection, enter
the ending port number of the range.
Schedule When Features Are Active
Configure Advanced Features
130
on page 68.