Table of Contents
Advertisement
EtherFast 10/100 LAN Card
10. NT will ask you to choose a media type for the 10/100 LAN Card. Choose AutoSense, as shown in Figure 6-39.
You can change these settings later if needed. Click the Continue button.
11. You may be asked if there if a DHCP Server on your network. Verify if there is, and whether you wish to use
DHCP. Click the Yes or No button on the following screen, shown in Figure 6-40, accordingly.
12. NT will copy the necessary network drivers to your PC. When the copying is complete, you will see a list of
installed bindings. These binding are appropriate to the Adapter you are installing. Click the Next button to
go through these two screens.
13. When you reach the following screen, shown in Figure 6-41, choose either Workgroup or Domain, depending
on the type of network you're setting up. (Your Microsoft documentation explains the difference between
Workgroups and Domains.) Click the Next button to continue.
14. On the next screen, click the Finish to complete installation. When asked if you want to restart your computer,
remove the Setup Utility CD and click the Yes button.
15. Once your PC has rebooted and you are logged in, double-click the Network Neighborhood icon on your
desktop. Make sure that you have access to the network. If you do, the Adapter has been properly installed.
The Windows NT Installation and Setup of the EtherFast® 10/100 LAN Card is complete.
Do not continue on with the next set of instructions. They are for NT users who already had their
Chapter 6: Manual Installation and Setup
Windows NT
networking configured.
Figure 6-39: Media Type
Figure 6-40: DHCP Server
Figure 6-41: Workgroup or Domain
29
Advertisement
Table of Contents
