Table of Contents
Advertisement
EtherFast 10/100 LAN Card
Chapter 6: Manual Installation and Setup
Overview
After installing the EtherFast 10/100 LAN Card in your computer, follow these instructions for installing the
network device driver. For troubleshooting tips during setup, refer to the Troubleshooting section.
The installation procedure for the network driver will vary depending on which version of Windows you are using.
Go to the section for your operating system.
Windows 95
The installation procedure for the network driver will vary slightly depending on which version of Windows 95 you
are using. To begin the driver installation, and to determine which version of Windows 95 you are using:
1. If you haven't already done so, start up your PC.
2. Windows 95 will automatically detect the EtherFast 10/100 LAN Card in your computer and an Update Device
Driver Wizard window (shown in Figure 6-1) will appear.
While the Update Device Driver Wizard window is visible, put the LNE100TX Setup Utility CD into your CD-ROM
drive and click the Next button. A screen will appear, shown in Figure 6-2 stating that Windows 95 was
unable to locate the driver. Click the Other Locations button to enter the driver's location manually.
Chapter 6: Manual Installation and Setup
Overview
Figure 6-1: Update Device
Figure 6-2: Unable to Locate Driver
11
Advertisement
Table of Contents
