Figure 6-29: Share-Level Access Control - Cisco Linksys LNE100TX User Manual

EtherFast 10/100 LAN Card
9. Choose the Access Control tab, as shown in Figure 6-29. Ensure that Shared-level access control is
selected.
10. Click the OK button. Your system may ask you for your Windows ME CD-ROM or the location of the Windows
ME installation files. If it does, direct Windows to the appropriate location, (i.e., D:\win9x, where D is the letter
of your CD-ROM drive, making sure you have the Windows ME CD-ROM, or C:\windows\options\install).
11. Once Windows has copied the necessary files, the System Settings Change window appears. Remove all
disks from your PC and click Yes to restart your PC. If you don't see this window restart your PC. Remember to
remove any disks prior to rebooting.
12. A Logon window will appear, requiring you to enter a User name and Password. Make up a user name and
password (if you haven't already), enter it here and click the OK button. Do not click the Cancel button or
press the Escape key. Clicking either of these buttons will prevent you from logging into the network. If the
logon does not appear or if it does not allow you to log on, refer to the Troubleshooting section.
13. Once you are at the Windows ME desktop, double-click the My Network Places icon, the Entire Network
icon, and then the Your Workgroup icon. You should see one icon for the entire network and the names of
the other PCs on the network.
If you can see your computer along with all the other computers on the network in Network
Neighborhood, then the Windows ME network configuration is complete. Continue with Appendix B:
Sharing Your Files and Printers if you want your PC's data or printer to be available to others on the
network. You may stop here, however, if you wish to configure File and Printer Sharing at a later time.
Refer to the Troubleshooting section if:
• You don't see anything at all in Entire Network and have pressed the F5 key on your keyboard a few times
to refresh the screen.
• You only see your own computer in Entire Network.
• You see all computers on the network except yours and have tried pressing the F5 key a few times.
• You only see computers that are running the same operating system as you and you don't see any others.
• After physically installing the EtherFast® 10/100 LAN Card in your computer, follow these instructions to
install the network device driver. The installation procedure for the network driver will vary slightly
depending on which version of Windows 2000 you are using, and on your current system configuration. If
at any time during the installation you encounter problems, consult the Troubleshooting section.
Chapter 6: Manual Installation and Setup
Windows ME

Figure 6-29: Share-Level Access Control

NOTE: If you have installed any Service Packs,
you will need to reinstall them after installing and
setting up the 10/100 LAN Card.
25