Makita 8433D Instruction Manual page 5

Specific Safety Rules
1 .
Hold tool by insulated gripping surfaces w h e n performing an operation where
the cutting tool may contact hidden wiring. Contact w i t h a "live" wire
will
also make exposed metal parts of the tool "live"
and shock the operator.
2. Be aware t h a t this t o o l is always in a n operating condition, because
it
does
not have t o be plugged i n t o an electrical outlet.
3.
Always be sure you have
a
f i r m footing.
Be sure n o one is below w h e n using the t o o l in high locations.
4. Hold the tool firmly.
5. Keep hands away from rotating parts.
6. Do
not leave the tool running. Operate t h e tool only w h e n hand-held.
7.
Do not touch the drill bit or the workpiece immediately after operation; they
may be extremely h o t and could burn your skin.
SYMBOLS
The followings s h o w the symbols used for tool
V
....................................
volts
-
....................................
direct current
n ,
....................................
no
load speed
.../
min
...................................
revolutions or reciprocation
per
minute
@
....................................
number
of
blow
5