Makita 8433D Instruction Manual page 12

ASSEMBLY
Installing or removing driver bit or drill bit
CAUTION
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit
Turn the sleeve counterclockwise to open
the chuck jaws Place the bit in the chuck
as far as it will go Turn the sleeve clock-
wise to tighten the chuck
To remove the bit, turn the sleeve counter-
clockwise
I
When not using the driver bit, keep it in the
bit holders. Bits 45 m m (1-3/4") long can
be kept there.
I
Side grip (auxiliary handle)
Always use the side grip to ensure operat-
ing safety. Install the side grip
so
that the
teeth on the grip fit in between the protru-
sions on the tool barrel.
Then tighten the grip by turning clockwise
at
the desired position. It may be swung
360" so as to be secured at any position.
8 1 1
Bit holder
L
Loosen Tighten
12