Breville Juice Fountain Crush Instruction Booklet page 19

CARE & CLEANING
Always ensure that the juicer is turned off
and the power cord is unplugged from the
power outlet before cleaning, disassembling
or assembling and storing the appliance.
1. Immediately after each use, use the
provided nylon brush to thoroughly
clean the fine mesh holes of the filter
basket. Brush the inside of the filter
basket under running water, holding it
up towards the light to ensure the fine
mesh holes are not blocked.
2. Use the filter brush provided with the
juicer. This brush has been specially
designed to clean the filter basket.
Simply place the filter basket inside the
brush and under running water twist the
brush left and right to remove the pulp
from the filter basket. You will need to
use the small brush provided to clean
the inside of the filter basket, this should
also be done under running water.
If the holes are blocked, soak the filter
basket in hot water with 10% lemon juice
to loosen the blocked holes.
18
TIP
If the filter basket cannot be cleaned
immediately after use, soak the filter
basket in hot soapy water immediately
after juicing is complete. If pulp is left
to dry on the filter basket, it may clog
the fine mesh holes, thereby lessening
the effectiveness of the juicer. Do not
soak the filter basket in bleach.
3. Wash the juice bowl, scraper wiper,
juicing screw, pulp container and juicing
jug in warm soapy water with the small
nylon brush provided or a soft cloth.
Rinse and dry thoroughly.
NOTE
Do not place any part of the juicer in
the dishwasher.
TIP
Discoloration of the plastic parts
may occur with brightly colored fruit
and vegetables. To help prevent this,
wash parts immediately after use. If
discoloration does occur, the plastic
parts can be soaked in 10% lemon
juice and water or they can be cleaned
with a non abrasive cleaner. Do not
soak the filter basket in bleach. Do not
soak the motor base.
4. Wipe the motor base with a soft damp
cloth and dry thoroughly. Do not use
abrasive scouring pads or cleaners when
cleaning the motor base as these may
scratch the surface. Wipe any excess
food particles from the power cord.