How To Use The Touch Controller - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
How to use the Touch controller
The basic function of the Touch controller is illustrated below.
The Touch controller and its use are described in full detail in
the User Guide for your video conference system.
Do not disturb is set here
Put the system in standby
Call someone
Basic operating principles
Tap the touch screen to wake
up the system, if needed.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces User interfaces Configuration
All settings are not available on all products; therefore the
touch buttons shown below may or may not be present on
your system.
Information bar
Tap a button to
activate its function.
Appendices
There is a brief overview of the Settings menu in the
The Settings menu on the Touch controller
Select headset, handset or speaker
Mute your microphone
Open the camera control
Scroll in lists
as outlined.
8
appendix.
Selfview
Change the volume
Any messages while
you were away is
indicated here
and Settings menu
Run a presentation
www.cisco.com