Configuring Ip - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
remote control and on-screen menu
Configuring IP
Your video conference system supports both IP version 4
(IPv4) and IP version 6 (IPv6).
In both cases, the IP parameters can be assigned
automatically by the network, or you can set everything
manually.
If you want to set the parameters manually please
contact your network administrator to obtain the required
parameters.
If an IP address is already assigned to your system, you will
find the current IPv4 and/or IPv6 address on the System
Information page:
Go to Home > Settings > System information.
The IPv4 Address and/or IPv6 Address of the system
is shown in the NETWORK section on the System
Information page.
Press Exit (the right most function key) to exit.
Always save the new value when you change a
setting
• Drop down list selection: Navigate to the correct
value and press the OK ( ) key to save, or press
the left arrow key to leave without saving.
• Text entry in an input field: Enter the text, navigate
to Ok/Save to save the change, or navigate to
Cancel to leave without saving; then press
OK ( ) to confirm.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration Configuration
1. Select IP version
i. Go to Home > Settings > Administrator settings > IP
settings.
ii. Select IPv4 or IPv6 in the IP version
according to your requirement.
2. Select automatic or manual IP assignment
i. Go to Configure > IP assignment.
ii. Select DHCP (IPv4) or Autoconf
assignment drop down list if you want automatic IP
assignment; select Static if you want to set the IP
addresses manually.
iii. Navigate to OK to save the change, or
without saving. Press OK ( ) to confirm.
IP version
The IP configuration is complete.
IPv4
a. Go to Configure, and set
On or Off
b. Navigate to
Cancel to leave without saving.
IPv6
DHCP Options:
1
Off: All IP parameters, except the IP address and gateway, must be set manually.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.
Appendices
3. Set the IP addresses
Set the remaining IP settings according to the table to
the right. The actions required depend on the IP version
and IP assignment method you selected in the previous
drop down list
steps.
4. Return to the main menu
Press
(IPv6) in the IP
Cancel to leave
IP assignment
DHCP/Autoconf
DHCPOptions to
according to your preference.
1
OK to save the change, or
Home ( ) to return to the home menu.
Static
a. Go to Configure and enter the IP Address,
Subnet Mask, Gateway, and DNS server.
a. Go to Configure, and enter the IP Address
and Gateway.
b. Set DHCPOptions to On or Off according to
your preference.
1
c. Navigate to OK to save the change or Cancel
to leave without saving.
www.cisco.com
22