Using The Web Interface For System Configuration - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
Web interface
Using the web interface for system configuration
You have to use the Touch controller or remote control for
the configurations until you know your system's IP address.
Finding the IP address
Tap More > Settings > System Information
controller; or navigate to Home > Settings > System
information if you use the remote control and on‑screen
menu.
In both cases you will find the IPv4 Address and/or IPv6
Address of the system in the NETWORK section on this
System Information page.
Signing in to the web interface
1. Open a web browser and enter the system's IP address
in the address bar.
2. Enter your user name and password and click
The default user name is admin with no password set.
If you are not able to connect to the system:
• Make sure the system and computer are connected to
the same network.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes
to allow the system to start up.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
on a Touch
Sign In.
Configuration Configuration Appendices
The web interface
26
www.cisco.com