Configuring Ip - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
Web interface
Configuring IP
Your video conference system supports both IP version 4
(IPv4) and IP version 6 (IPv6).
In both cases, the IP parameters can be assigned
automatically by the network, or you can set everything
manually.
If you want to set the parameters manually please
contact your network administrator to obtain the required
parameters.
If an IP address is already assigned to your system, you will
find the current IPv4 and/or IPv6 address on the System
Information page:
Go to the Diagnostics tab and select
The IP address of the codec is shown in the top section.
Save the new value when you change a setting
Click ok to save the change, or cancel
saving.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
1. Select IP version
Go to the Configuration
Configuration.
Click on Network 1
which IP version to use in the
2. Select automatic or manual IP assignment
For IPv4: Click on the
DHCP or Static
For IPv6: Open the
Assignment
down list.
System Information.
IPStack
to leave without
IPv4
IPv6
Configuration Configuration Appendices
tab and select Advanced
and then on the IPStack value. Select
IPStack drop down list.
Assignment value and select
in the drop down list.
IPv6 folder and click on the
value. Select Autoconf or Static in the drop
DHCP/Autoconf
The IP configuration is complete.
a. Select On or Off in the DHCPOptions
down list according to your preference.
DHCP Options:
1
Off: All IP parameters, except the IP address and gateway, must be set manually.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.
3. Set the IP addresses
Set the remaining IP settings according to the table to
the right. The actions required depend on the IP version
(IPStack) and IP assignment method (Assignment) you
selected in the previous steps.
Assignment
Static
a. Open the IPv4 folder; click on the Address,
SubnetMask and Gateway
the addresses in the corresponding input
fields.
b. Open the DNS folder, and then the
Server 1 folder; click on the
and enter the DNS server address in the
corresponding input field.
drop a. Select On or Off in the DHCPOptions
down list according to your preference.
1
b. Click on the Address and
to enter the system IP address and the
gateway address in the corresponding input
fields.
27
values and enter
Address value
drop
1
Gateway values
www.cisco.com