Setting Date, Time And Location - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
touch controller
Setting date, time and location
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
The time is shown in the top right corner of the Touch
controller display.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration Configuration
1. Tap More > Settings > Administrator settings > Date,
Time & Location.
2. Tap 24h or 12h to select the Time format
3. Tap dd.mm.yy, mm.dd.yy or yy.mm.dd
format you prefer.
4. Select the Time zone you are in. Step through the list of
available zones by tapping the ‑ or + signs.
5. Select Auto, Manual or Off to select the
prefer. 1
If you select Manual, also enter the
in the corresponding input field.
If you select Off, also select the correct value for Hour,
Minute, Year, Month, and Day
section. Tap the plus and minus signs to increase or
decrease a value.
6. Tap Save to save the changes, or
saving.
7. Tap Exit to return to the home menu.
1 NTP mode:
Auto: The time is regularly updated using an NTP server. The
NTP server address is automatically obtained from the
network (DHCP).
Manual: The time is regularly updated using an NTP server. You
must manually enter the NTP server address.
Off: You must set the time manually. The time will not be
updated automatically.
Appendices
you prefer.
to select the Date
NTP mode you
NTP server address
in the Date and time
Undo to leave without
19
www.cisco.com