Using The Touch Controller For System Configuration - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
touch controller
Using the Touch controller for system configuration
Waking up the system
If no menu is displayed on the Touch controller, tap the
display to wake up the system.
If the system does not wake up:
• Make sure the Touch controller is connected to the main
unit.
• Make sure the main unit is connected to power and
switched on.
If the system has just been switched on, wait a few minutes
to allow the system to start up.
If in doubt, read the Installation guide for your product.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration Configuration Appendices
Touch controller
16
www.cisco.com