Honda 1995 Civic Coupe Online Reference Owner's Manual page 63

Select the band you want to
listen to by pressing the AM or
FM 1-2 button. You will see the
selected band and the frequency
in the display.
ST will be displayed next to the
frequency if the station is
broadcasting in FM stereo. The
AM stereo feature is not
available.
You can use any of three
methods to find radio stations on
the selected band: TUNE, SEEK,
or the Preset buttons.
The TUNE function lets you find
a desired frequency. Push the
right side of the TUNE/SEEK
bar to change to a higher
frequency, and push the left side
of the bar to change to a
lower frequency.
To change the frequency up or
down a single increment, push
and release the TUNE/SEEK bar.
The SEEK function searches the
band for a station with a strong
signal. Depending on which way
you push the TUNE/SEEK bar,
the system searches up or down
from the current frequency. Push
the bar until you hear a beep,
then release it. The system
searches until it finds a station
with a strong signal, then stops.
Presetting Radio Stations
The preset buttons allow you to
store radio frequencies for later
selection. Each button will store
one frequency on the AM band
and two on the FM band. To
store a frequency do this:
1. Select the desired band, AM
or FM. FM 1-2 allows you to
store two frequencies with
each Preset button.
2. Use the TUNE or SEEK
function to tune the radio to
a desired station.
3. Pick the Preset button you
want for that station. Press
the button and hold it until
you hear a beep. The light in
the indicator will come on
and the station selected will
show in the display.
4. Repeat steps 1 through 3 to
store a total of six stations on
AM and 12 on FM.
Once a station's frequency is
stored, simply press and release
the proper Preset button to tune
to it. If you want to change any
Preset button's selection, store
another frequency as described.
The frequencies you preset will
be lost if your car's battery goes
dead or is disconnected.
Comfort and Convenience Features
Audio System