Toshiba e-STUDIO2500c Service Manual page 348

(6) Remove 1 screw, and then take off the cen-
ter heater lamp, side heater lamp and lamp
front bracket.
Note:
When installing them, pull the harness under
the stay.
(7) Remove 4 screws, and then release the har-
ness out of 1 clamp to take off the fuser belt
sensor bracket and the lamp rear bracket.
(8) Remove 2 E-rings from the fuser roller. Then
remove 2 washers, 2 bushings and 2 bear-
ings.
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
Center heater lamp
Clamp
Lamp rear bracket
Washer
Bearing
Bushing
15 - 24
Side heater lamp
Lamp front bracket
Fig. 15-29
Fuser belt sensor bracket
Fig. 15-30
Bearing
Bushing
Washer
Fuser roller
Fig. 15-31
May 2006 © TOSHIBA TEC