Toshiba e-STUDIO2500c Service Manual page 302
Multifunctional digital color systems
Hide thumbs
Also See for e-STUDIO2500c:
- Operator's manual (414 pages) ,
- Scanning manual (156 pages) ,
- Colour manual (8 pages)
Table of Contents
Advertisement
[B] Transfer belt unit (TBU)
[B-1]
Transfer belt unit (TBU)
Notes:
It is recommended to wear gloves to avoid a direct touch on the belt surface. When any of the fol-
lowing maintenance works has been done, be sure to adjust the axis gap of the TBU drive gear.
SERVICE HANDBOOK "3.15 Adjustment of the axis gap of the TBU drive gear"
•
Replacing the transfer belt .
•
Disassembling the roller or frame of the transfer belt unit (except when only the transfer belt
or drive roller is disassembled).
(1)
Take off the transfer belt cleaning unit.
P.13-11 "[A-1] Transfer belt cleaning unit"
(2)
Remove 1 screw, and then turn the TBU lift-
ing lever counterclockwise for 90 degrees.
(3)
Move the automatic duplexing unit to its
maintenance position.
P.16-13 "[A] ADU maintenance position"
(4)
Open the 2nd transfer unit and ADU.
(5)
Open the middle guide by holding its knob.
Note:
Do not hold the middle guide itself when
opening and closing it.
(6)
Disconnect the 1 connector.
e-STUDIO2500c/3500c/3510c TRANSFER UNIT
Connector
13 - 14
TBU lifting lever
Fig. 13-11
Knob
Middle guide
Fig. 13-12
May 2006 © TOSHIBA TEC
Advertisement
Table of Contents
