Toshiba e-STUDIO2500c Service Manual page 225

(5) Remove 2 holders, 3 E-rings, 1 gear and the
grounding plate.
[N] Registration motor unit
(1) Open the board case.
P.2-43 "[K] Board case"
(2) Disconnect 1 connector and remove 4
screws. Then take off the registration motor
unit.
Note:
Be sure not to drop the bushing.
[O] Registration motor (M19)
(1) Open the board case.
P.2-43 "[K] Board case"
(2) Take off the registration motor unit.
P.10-37 "[N] Registration motor unit"
(3) Remove 3 screws to take off the plate.
May 2006 © TOSHIBA TEC
Registration roller ( Rubber )
Bushing
Fig. 10-71
Registration motor unit
Fig. 10-72
Fig. 10-73
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
10 - 37
Bushing
Plate
Gear
Plate
10