Cisco 521 Manual page 20

Step 3 Remove a ceiling tile adjacent to the mounting location.
Step 4
Configure the ends of the T-bar box hanger to allow for maximum
clearance above the ceiling tile.
Step 5
Open the access point cover and connect the Ethernet cable to the
access point.
Step 6 Attach the access point to the access point mounting bracket.
Step 7
Attach the T-rail clips on each end of the T-bar box hanger to the
ceiling grid T-rails. Make sure the clips are securely attached to the
T-rails.
Step 8 Connect a drop wire to a building structural element and the hole
provided in the bracket mounting clip. This additional support is
required in order to comply with the U.S. National Electrical Safety
Code.
20
OL-16715-01