Cisco 521 Manual page 11

Complete these steps to prepare for installation.
Step 1
Carefully unpack and remove the access point and hardware kit
from the shipping box.
Step 2
Return all packing material to the shipping container, and save it.
Step 3 Verify all the package contents, and inspect each item for damage.
If any item is missing or damaged, contact your Cisco
representative for support.
Deploying Standalone Access Points
In the standalone architecture, you can deploy up to three standalone AP521s
and configure them using the CCA. These access points can be upgraded later
into a controller-based architecture. This procedure assumes that you are
using a UC500, a CE520, and the CCA.
Refer to the Cisco Smart Business Communications System Setup document,
Section 4, "Deploy Basic or Multi-AP Wireless," follow the steps listed in the
section entitled "Deploy Cisco 521 Series Wireless Express Access Points in
Standalone Mode" to deploy your standalone AP521s.
Quick Start Guide: Cisco 521 Wireless Express Access Point
11