Table of Contents
Advertisement
Option 6: Call Waiting
The Call Waiting option allows you to program a code (up to 26 digits) that
disables call waiting and other phone services prior to dialing the central
monitoring station or a pager/voice event notification system.
When programming the Call Waiting option, press Add to enter a * symbol;
press Delete to enter a # symbol; press Test to enter a pause.
Note
If Call Waiting is enabled on a phone that does not support the feature, the panel
cannot contact the central monitoring station.
Option 7: Not Available
Option 8: Communication Lock
The Communication Lock option allows you to change or delete specific
phone or code options. When enabled, the Communication Lock option pre-
vents phone/report functions for Options 3, 4, 6-11, and Utility Access
Code 1 from being reset during a memory clear.
When this option is turned OFF, the listed options are reset to default values.
Option 9: Downloader Code
The Downloader Code option allows you to establish a unique, five-digit
code for initiating a Remote Programmer session. The Downloader Code
must contain five digits and can range from 00000 to 99999.
To conduct a downloader session and transfer data, this code must also
match the Downloader Access Code found in the Remote Programmer
account.
Note
To avoid competitor theft, the Downloader Code should be changed from the
default setting.
Option 10: Phone Mod 1
The Phone Mod 1 option determines the content and format the panel
reports through the Primary Phone Number (Option 3). When deleted, the
option is set to OFF. See Table 2 for a complete list of Phone Mod 1 settings.
Note
For ETL listed systems, Phone Mode 1 must be set to either 0 or 1.
11
Table 2: Phone Mod 1 Settings
Setting
Content
0
All
1
All
2
Alarms Only
3
Alarms Only
Range = 26 Digits (Default = Off)
¾
To program a Call Waiting code:
1. Press Add.
2. Press Option #.
3. Press 0, then 6.
4. Enter the Call Waiting code and use Add,
Delete, and Test as necessary.
5. Press Done.
¾
To program Communication Lock:
1. Press Add or Delete.
2. Press Option #.
3. Press 0, then 8.
4. Press Done.
Range = 00000-99999 (Default = 12345)
¾
To program a Downloader Code:
1. Press Add.
2. Press Option #.
3. Press 0, then 9.
4. Enter the Downloader Code.
5. Press Done.
¾
To program Phone Mod 1:
1. Press Add.
2. Press Option #.
3. Press 1, then 0.
4. Enter the Phone Mod 1 setting.
5. Press Done.
Format
SIA
Contact ID
SIA
Contact ID
Range = On/Off (Default = Off)
Range = 0-3, Off (Default = 0)
Programming Options
Advertisement
Table of Contents
