NEC Univerge SV8100 Features And Specifications Manual page 1500

Issue 12.0
Program
Program Name
Number
35-02-14 SMDR Output Options – Date
35-02-15 SMDR Output Options – CLI/DID
Number Switching
35-02-16 SMDR Output Options – Trunk
Name or Received Dialed
Number
35-02-17 SMDR Output Options – Print
Account Code or Caller Name of
Incoming Call
35-02-18 SMDR Output Options – Print
Mode for Caller Name of
Incoming Call
2 - 1470
Description/Comments
Determine whether or not the date
should be displayed on SMDR
reports.

This option must be set to 0 if
the trunk name is set to be
displayed in Program
35-02-03.
Determine whether the CLI or DID
Calling Number should be
displayed.
Determine how the SMDR should
print incoming calls on ANI/DNIS
or DID trunks. If set to 1, ANI/DNIS
trunks can print DNIS digits.If set
to 0 trunk names are printed
instead (assigned in Program
14-01-01).
Determine whether the Account
Code or Caller ID name should
print in the SMDR record.

Program 35-01-08 must be
set to 0 for this entry to be
followed.
Determine how SMDR should print
Caller Name of incoming call.
Select whether to display up to 16
characters of the Caller Name on
the same line as the call record (0)
or if a line feed should be added
and up to 24 characters of the
Caller Name are displayed on the
following line (1). If the line feed
option is selected, the Caller
Name is displayed on the next line
as : NEXT Caller Name.
This setting works regardless of
the setting in Program 35-02-15.

With this option set to 1, if
your communications
program (such as
HyperTerminal) has the line
wrap option enabled in the
ASCII setup, an additional
line break may appear above
the Caller name line.
UNIVERGE SV8100
Assigned Data
0 = Not Displayed
1 = Displayed
(default = 0)
0 = CLI (CLIP)
1 = DID Calling
Number
2 = Caller ID Name
(default = 0)
0 = Trunk Port Name
1 = Received Dialed
Number
2 = Both
(default = 0)
0 = ACC
1 = CNAME
(default = 0)
0 = Normal
1 = Line Feed
(default = 0)
Station Message Detail Recording
Level
1 2 3




