Back Panel - Cisco IPN330HD Installation Manual

Back Panel

NETWORK
1
1 Network
2 USB Port
3 HDMI
4 YPbPr
5 S-Video
6 Video Out
7 Audio Out (L/R)
8 Optical
9 To TV (Video Out)
10 To Wall (Video In)
11 Power
Note: This illustration may vary from the actual product.
Pb Y
Pr
USB S-VIDEO
2 3 4 5
Connect to the Ethernet (CAT-5) network at your home, if applicable
USB connector. (Reserved for future use)
Connect an HDTV HDMI
from the HDTV to the HDMI port. HDMI supports both digital audio and
video. See page 12 for more information
Connect the receiver to the component video input (YPbPr) on the
HDTV. See pages 12 and 13 for more information
Connect an S-Video cable to send an S-Video signal to your TV, VCR, or
DVD recorder. This signal is standard-defi nition but higher quality than
other standard-defi nition TV connections. See page 13 for more
information
Connect to composite input on your HDTV or SDTV
Note: Two video output connectors are provided. Typically, one output
is connected to the TV, and the other output is used to connect to a
home theater system, DVD recorder, or VCR
Connect RCA-type cables to Audio Out to send analog audio signals
(left and right) to a TV with stereo inputs or to a stereo amplifi er
Note: Two sets of audio out connectors are provided. Typically, one set
of outputs is connected to the TV, and the other set is used to connect
to a home theater system, DVD recorder, or VCR
Connect an optical cable to send a digital audio signal to a surround-
sound receiver or other digital audio device
Connect to TV. You must set the channel on your TV to the channel
designated by your service provider (usually channel 3). Contact your
service provider for the channel information
Connect the receiver to in-house coaxial wiring, if applicable
Connect the DC output of the AC power adapter (provided) to deliver
power to the receiver
L R
VIDEO AUDIO
OPTICAL
OUT OUT
6 7 8
(High-Defi nition Multimedia Interface) cable
™
TO TV TO WALL
POWER
(VIDEO OUT) (VIDEO IN)
9
10 11
T12401
9