The Standby Settings - Cisco EX90 Administrator's Manual

Cisco TelePresence System EX90/EX60
Contents

The Standby settings

Standby Control
Determine whether the system should go into standby mode or not.
Requires user role: ADMIN
Value space: <On/Off>
On: Enter standby mode when the Standby Delay has timed out. Note: Requires the Standby Delay
to be set to an appropriate value.
Off: The system will not enter standby mode.
Example: Standby Control: On
Standby delay
Define how long (in minutes) the system shall be in idle mode before it goes into standby mode. Note:
Requires the Standby Control to be enabled.
Requires user role: ADMIN
Value space: <1..480>
Range: Select a value from 1 to 480 minutes.
Example: Standby Delay: 10
Standby WakeupAction
Not applicable in this version.
Standby BootAction
Not applicable in this version.
Standby StandbyAction
Not applicable in this version.
D14726.03 Cisco TelePresence System EX90-EX60 Administrator Guide TC4.0, December 2010.
Copyright © 2010 Cisco Systems, Inc. All rights reserved.
Introduction Using the web interface Advanced configuration
The SystemUnit settings
SystemUnit MenuType
Not applicable in this version.
SystemUnit Name
Enter a System Name to define a name of the system unit. If the H.323 Alias ID is configured on the
system then this ID will be used instead of the system name. The system name will be displayed:
1) When the codec is acting as an SNMP Agent.
2) Towards a DHCP server.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: SystemUnit Name: "Meeting Room"
SystemUnit MenuLanguage
Select the language to be used in the menus on screen.
Requires user role: USER
Value space: <English>
Example: SystemUnit MenuLanguage: English
SystemUnit IrSensor Mode
Not applicable in this version.
SystemUnit ContactInfo Type
Not applicable in this version.
SystemUnit CallLogging Mode
Set the call logging mode for calls that are received or placed by the system. The call logs may then
be viewed via the GUI or using the xHistory command.
Requires user role: ADMIN
Value space: <On/Off>
On: Enable logging.
Off: Disable logging.
Example: SystemUnit CallLogging Mode: On
45
Administrator guide
Appendices
www.cisco.com