Configuring Windows For Tapi - Cisco 7960 User Manual

14. Click OK in the dialog box.
15. Click Finish in the Installation Complete dialog box to complete the TAPI
program installation.
NOTE: Before you can dial from the TAPI-enabled program, you must and to
use the telephone line."Configuring Windows for TAPI" on page 94 and
"Configuring Outlook to Use TAPI" on page 101.

Configuring Windows for TAPI

For TAPI-enabled programs to be able to dial using the TAPI Service Provider,
Windows must be configured correctly to be able to use the proper line, get an
outside line, and dial correctly.
General Information
The following notes apply to all TAPI-enabled programs:
•
•
•
Setting Up TAPI
Use the following steps to set up TAPI 2.1-compliant Service Provider in Windows.
These steps are from Windows XP. Other Windows versions should be similar.
1. Click Start and Control Panel to open the Control panel window.
118 Set Up Outlook for TAPI
The program must be set to use Tekelec T6000 Telephone Service
Provider that must be installed on your PC.
The access codes required for outside calls (usually 9 or 8) must be
configured.
Instructions for handling area codes and, if necessary, 10-digit dialing
must be configured.
Cisco 7960/7940 Telephone User Guide
620-05600230