Connecting Other Hardware - Honeywell HNDR series User Manual

Chapter 8. Appendix
Chapter 8. Appendix

1. Connecting Other Hardware

1.1. Connecting PTZ Device
Serial communication
cable
• Connect COM1 PORT (
the HNDR PCI Slot to the provided RS-232 cable.
• Connect D-SUB 9-Pin Port for connecting RS-485 attached (
HNDR as shown below. (The D-Sub 9-Pin Connector is provided.)
Caution 13. Notes on connecting PTZ
!
COM1
1
) on the rear of the HNDR and the D-SUB 9-Pin Port attached (
1
RS-485 Connection
Pin Name
- TX Data
+ TX Data
Pay attention to the polarity ((+), (-)) of signal lines.
Incorrect wiring combination may result in malfunction of the equipment.
Connect to RS-485
Com. port of RECEIVER
Pin Number
66
RS-485 Board
2
3
S- (1)
S+ (2)
) to the PCI slot on the rear of the
3
1
2
) to
2