Cisco TelePresence System Quick Set C20 / C20 Plus and Profiles using C20
Contents
Introduction
Codec C20 — The physical interface
The front panel LEDs
The LED in front of the codec indicates the status of the codec.
• When the LED is
off
the codec is Off.
• The LED flashes
green
during the boot up and shut down of
the codec.
• The LED pulses
green
when the infrared (IR) port is activated.
This will occur when the remote control is in use.
• The LED is steady
green
when the codec is On, in Standby
mode or in Presentation mode.
• When the LED is
red
this indicates an Error has occurred.
D14637.06
Profile C20 and Quick Set C20 Administrator Guide TC4.2, July 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Web interface
Power
Call
IR
Alarm
(infrared)
Advanced settings
Password protection
72
Administrator guide
Appendices
Appendices
Contact us
www.cisco.com