Installing The Ip Camera - Cisco 6050 Installation Manual

Chapter 2 Camera Installation
Figure 2-1
1
Tamper-proof screw.
2 Dome cover.
3 Plastic cover.
4
Camera base.
(Optional) Insert your microSD/SDHC card, if needed. See
•
If the device (PoE enabled switch or PoE power injector) to which you are connecting the IP camera
•
does not have a port for an M12 connection, obtain an M12 to RJ45 adapter. You can then connect
an STP (shielded twisted pair) Category 5 or higher network cable from this adapter to your device.
The M12 to RJ45 adapter is available for purchase from Cisco (Cisco part number
CIVS-6KA-M12RJ45).
To install the IP camera, follow these steps:
Procedure
Step 1 Attach the included alignment sticker to the ceiling or wall.
Using the three circle marks on the alignment sticker, drill three pilot holes into the ceiling or wall, then
Step 2
put the included screw anchors into the holes.
Use a hammer to drive the anchors into the holes, if needed.
Route the cable from the IP camera through the camera base and then through ceiling or wall, drill a
Step 3
cable hole as shown in the following figure, then feed the cable through the hole.
OL-31413-01
Detaching the Dome Cover from the IP Camera
Figure 1-1 on page
Cisco Video Surveillance 6050 IP Camera Installation Guide

Installing the IP Camera

1-2.
2-3