Table of Contents
Advertisement
Chapter 4
Camera Management
Powering the IP Camera On or Off
The IP camera does not include an on/off switch. You power it on or off by connecting it to or
disconnecting it from a power source. When you power off the IP camera, configuration settings are
retained.
To power on the IP camera, use an STP (shielded twisted pair) Category 5 or higher network cable to
connect the IP camera to a switch or power injector that provides 802.3af compliant PoE.
To power off the IP camera, unplug the adapter from the wall or disconnect it from the camera
Resetting the IP Camera
You reset the IP camera by pressing the Reset button on the IP Camera (see
There are various reset types, as described in
You also can also perform these reset operations from the Maintenance Settings window as described in
the Cisco Video Surveillance 6000 Series IP Camera Configuration Guide.
Table 4-3
Reset Type
Reboot.
Factory reset.
Viewing Live Video
After you install and set up the Cisco Video Surveillance IP Camera, you can connect to the IP camera
through Internet Explorer and access the Camera Video & Control window to view live video.
The Camera Video & Control window also provides for controlling the video display, configuring preset
positions, and controlling certain IP camera functions. Available controls depend on the privilege level
of the user.
OL-31413-01
Resetting the IP Camera
Procedure
Press and immediately release
the Reset button.
Press and hold the button for at
least 15 seconds.
Table
4-3.
Remarks
This action is equivalent to
powering the IP camera down
and then powering it up. Settings
that are configured for the IP
camera are retained.
Sets all IP camera options to
their default values. After you
perform this procedure, follow
the steps in the
Initial Setup of the IP Camera"
section on page
Cisco Video Surveillance 6050 IP Camera Installation Guide
Powering the IP Camera On or Off
Figure 1-1 on page
1-2).
"Performing the
3-1.
4-7
Advertisement
Table of Contents
