Installing The Ip Camera - Cisco 6000 Installation Manual

Installing the IP Camera

Installing the IP Camera
To install the Cisco Video Surveillance 6000P IP Camera, perform the following steps:
Procedure
Turn the lens clockwise into the lens opening until it stops (see
Step 1
counterclockwise slowly until it gets the best attitude. The IP camera accepts CS-mount lenses with a
lens protrusion of up to 5 mm.
Figure 2-1
Ensure that the lens is clean because any dirt may degrade the quality of video images.
Note
Connect the P-iris lens cable to the P-iris lens connector on the back of the IP camera (see
Step 2
Figure 2-2
Optional. Use the GPIO terminal block ports on the back of the IP camera to connect an external device
Step 3
that triggers alarms (connect through input port) or responds to alarms (connect through output port).
Figure 2-3
Cisco Video Surveillance 6000P IP Camera Installation Guide
2-4
Mounting the IP Camera Lens
Save the lens opening dust cap and replace the dust cap if you remove the lens.
Mounting the IP Camera Lens
shows the GPIO terminal block pin locations and descriptions.
Chapter 2 Camera Installation
Figure 2-1). If necessary, turn it
Figure 2-2).
OL-28118-01