Cisco 6050 Installation Manual page 15

Chapter 2 Camera Installation
Step 6 Use one of the following methods to connect the IP camera to power.
To connect the IP camera if you are powering it with PoE through a PoE-enabled switch, connect
•
the IP camera to the switch as shown in the following figure.
Use an M12 to RJ45 adapter and an Ethernet cable if the switch to which you are connecting the IP
camera does not have a port for an M12 connection.
Use the provided waterproof connector for the M12 cable or the waterproof adapter that is provided
with the M12 to RJ45 adapter if you need an IP67 connection. (See the
section on page 1-3
To connect the IP camera if you are powering it with PoE through a non-PoE switch, connect the IP
•
camera to the switch through a PoE power injector as shown in the following figure.
Use an M12 to RJ45 adapter and an Ethernet cable if the power injector to which you are connecting
the IP camera does not have a port for an M12 connection.
Use the provided waterproof connector for the M12 cable or the waterproof adapter that is provided
with the M12 to RJ45 adapter if you need an IP67 connection. (See the
section on page 1-3
OL-31413-01
for pinout information.)
for pinout information.)
Cisco Video Surveillance 6050 IP Camera Installation Guide
Installing the IP Camera
"M12 Connector Pinouts"
"M12 Connector Pinouts"
2-5