Omnidirectional Mounting Procedure; Connect Antenna To Transmitter; Figure 20 Omnidirection Antenna Mounting - Honeywell XYR 6000 Quick Start Manual

4. Antenna adjustment and mounting
4.3. Remote antenna

Omnidirectional mounting procedure

Step
1
Secure mast mounting bracket to mast as shown using 2 U-bolts and supplied hardware.
2
Remove antenna mounting bolt and washer from antenna base.
3
Insert antenna into mounting bracket and secure with washer and antenna mounting bolt. Do
not overtighten.
4
Any drain holes in the antenna base must be kept clear for proper operation.

Connect antenna to transmitter

Using coaxial cable, connect the antenna base to the transmitter's remote antenna connector (located at top
right as you face the transmitter display). A lightning arrestor may be required between the antenna and the
transmitter, using two cables up to 10m long each. Without lightning arrester, total cable length must not
exceed 10m (33 ft.). With lightning arrester total cable length must not exceed 20m (66 ft.). Antenna cable
shield is bonded to earth ground via either the transmitter earth ground connection or the lightning arrestor
earth ground connection. The lightning arrestor must be bonded to earth ground to function properly.
See page 37 for cable types and connection information.
28

Figure 20 Omnidirection antenna mounting

OneWireless XYR 6000 Transmitters Quick Start Guide
Action
Revision 3
8/8/07