5.1
Connect batteries
WARNING
Risk of death or serious injury from explosion or fire.
Connection and disconnection of the batteries should be done only when the
area is non-hazardous.
ATTENTION
Both batteries must be the same model from the same manufacturer. Mixing
old and new batteries or different manufacturers is not permitted.
Use only the following 3.6V lithium thionyl chloride (Li-SOCl2) batteries (non-
rechargeable), size D. No other batteries are approved for use in XYR 6000
Wireless Transmitters.
•
Xeno Energy XL-205F
•
Eagle Picher PT-2300H
•
Tadiran TL-5930/s
•
Honeywell p/n 50026010-001 (Two 3.6V lithium thionyl chloride
batteries)
•
Honeywell p/n 50026010-002 (Four 3.6V lithium thionyl chloride
batteries)
•
Honeywell p/n 50026010-003 (Ten 3.6V lithium thionyl chloride batteries)
Step
1
Loosen the M3 locking set screw on the battery end-cap (opposite end from display). See item
1 in Figure 21. Unscrew and remove the end cap.
2
Attach connector to batteries as shown.
3
Screw the end cap back on and tighten the M3 locking screw.
Revision 3
8/8/07
5. Start up
OneWireless XYR 6000 Transmitters Quick Start Guide
Action
5. Start up
5.1. Connect batteries
29