Alternative Mode Programming; Www.diyalarmforum.com - Honeywell AlarmNet 7845GSM Installation And Setup Manual

Refer to Table 5 for 4204 Emulation Mode programming and follow the prompts that pertain
to 4204 or Two-4204 mode. Check marks (
mode.

Alternative Mode Programming

Press the [ENTER] key to begin programming
operation being programmed.
NOTE: The central station can remotely block access to
Table 5: Programming a 7845GSM for Zone Trigger, 4204 Emulation, or Two-4204 Emulation modes.
PROMPTS
Strt Prog Mode?
1
(Y/N)_
Enter Password
2
Program 7845?
3
(Y/N)_
Create Password?
4
(Y/N)_
Change Password?
5
(Y/N)
Enter Password
6
Verify Password
7

WWW.DIYALARMFORUM.COM

local device programming. If this has been done,
the following prompt appears:
4204/
ZONE
ENTRY
2-4204
TRIG.
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔
WWW.DIYALARMFORUM.COM
Section 3: Programming the 7845GSM
✔)
indicate whether the prompt applies to that
ollow the prompts for the mode of
and f
Access to Prog
Mode Denied
OPTIONS
Enters programming mode.
[Y], [N]
[0-9, A-F, N, If a password has been previously assigned, this
S, T, X, Y]
prompt appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
The next prompt appears.
[Y], [N] To begin programming the module, press [Y] and
go to Prompt 9: "Device Mode."
To create a password if none has been assigned,
press [N] and go to Prompt 4: "Create Password."
To change an existing password, press [N] and go
to Prompt 5: "Change Password."
[Y], [N] Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program 7845?"
prompt.
If a password is desired, press [Y] and go to Prompt
6: "Enter Password."
[Y], [N] If a password has already been assigned, this
prompt appears after pressing [N] at the "Program
7845?" prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key
when prompted for the new password and its
confirmation.
[0-9, A-F, N, If [Y] was pressed in Prompt 4 or 5, this prompt
S, T, X, Y] appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
[0-9, A-F, N, Re-enter the password as confirmation.
S, T, X, Y] If the password doesn't match the first entry, the
following is displayed followed by the "Exit Prog.
Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is
displayed directly.
DESCRIPTION
3-9