Modifying The Gsm Pin; Parameters - Honeywell XI581AH User Manual

ALPHABETIC REFERENCE

Modifying the GSM PIN

Access Level
Select System Data from Main Menu

Parameters

EN2B-0126 (74-3554-8)
Purpose To enable communication via GSM, a password (PIN) must be entered into the con-
troller. This password must be entered again after any controller reset or power-up.
GSM pin entry at start-up is described in the "Start-up and Configuration" section.
You must have access level 3 to perform this task.
1. At the Main Menu, use the arrow keys to move to and highlight System Data.
Press Enter (↵) to complete the selection.
RESULT: The 'System Data' screen displays four possible options (depending
System Data
2. Use the arrow keys to move to and highlight HW-Interface Config. Then press
Enter (↵) to complete the selection. The following screen displays.
HW-Interface Configuration
C-Bus
Lon-Bus
B-Port
3. Use the arrow keys to move to and highlight Modem (found by scrolling to below
B-Port) and press Enter (↵) to complete the selection. The 'Modem
Configuration' screen is displayed.
Modem Configuration
Baudrate:
GSM PIN : ********
Reset Modem
4. When selecting the 'GSM PIN' field:
Press Enter (↵) to select the field. The first, left-most digit in the field begins
blinking.
Press the plus or minus keys to increment/decrement the digit.
Press left/right arrow keys to move to next digit.
When completed, press Enter (↵) once to confirm PIN.
NOTE: The PIN must be entered right-justified.
IMPORTANT:
For GSM communication MODEM PART must be enabled, and the modem
baud rate must be set at 9600.
Purpose To view and modify the value of parameters stored in the parameter files.
XI581/2 BUSWIDE OPERATOR INTERFACE
on access level).
System Info
HW-Interface Config.
Flash EPROM
Buswide Access
9600
66
L L L L
1
M
NEXT